Fluff out wreath form. Take your 10" mesh and cut (18) 30" pieces.
Take each of the 18 pieces of mesh, scrunch down the center, and add to every wreath tie. This is the ruffle method. Do start at the bottom of the wreath frame and work your way to the top to avoid getting tangled up.
Get out your ribbon tail board, 2.5" ribbon, and 1.5" ribbon.Wrap 2.5" ribbon around the ribbon tail board and cut into (18) 14" strips.Wrap 1.5" ribbon around the ribbon tail board and cut into (36) 14" strips. Cut ends into dovetails.
Layer (2) 1.5" ribbon strips on top of (1) 2.5" ribbon strip, fold in half, scrunch in middle, and add to the wreath ties. Start with the bottom row.Fan out the ribbon tails. and Make sure it all points out to make the wreath look bigger.Repeat until you add ribbon tails to each wreath tie on the bottom and then the top ties.
Get your wreath sign, pipe cleaners, and staple gun. Staple a pipe cleaner to each corner on the back of the sign. Add sign to wreath frame in the center. Thread pipe cleaner around the back and tie nice and tight.
Then add your bow to your wreath to the bottom right of the sign.
Take (5) of the 2.5" ribbons and cut 10" strips to make ribbon tails. Scrunch one end and wrap a zip tie around, threading a pipe cleaner for good measure. Trim the excess of the zip tie. Trim the ends of the ribbon tails into dovetails. Fluff out the tails.Add the ribbon tails underneath the bow. Use the pipe cleaner to attach to the wreath form.
Take (3) of the 2.5″ ribbons and cut 24″ strips. Take the first strip and fold it in half (tails facing the bottom). Take the next strip and fold it in half (tails facing the top). Then take the last strip and fold it in half (tails facing the bottom).Layer each one on top of the other and then fold all in half and scrunch at the center. Dovetail all the ends.