Set up your Pro Bow the Hand with 6 pegs on each side in Row E. Your three rolls of ribbon should be in the accompanying spool holder.
Cut two lengths of floral wire at 30 inches and fold in half.
Holding all three ends of the ribbon together, pull them simultaneously and then create a crease by folding the ribbon over one inch (thumb length). Pinch ribbon at the fold and wrap the wire around the ribbon, about three times.
Take your three ribbons and loop around the first peg on the left of your Pro Bow (design facing out). Wrap the end of the ribbon around the bottom peg and the top wire around the bottom peg, then wrap the bottom wire around the nail of the Pro Bow several times. Tuck your extra wire under the Pro Bow.
Add the second length of floral wire around the ribbon to create extra stability.
Bring the ribbon down to the bottom peg, then pinch and twist it so that the design faces out.vLoop around the first peg on the right side.
Bring the ribbon down to the bottom peg, pinch and twist the ribbon, then loop it around the second peg on the left.
Repeat steps until you have made six loops on each side.
Unwrap the wires and tie off the bow. Dovetail the ends of the ribbon and attach your bow to the Fluff Box.
Starting in the center, fluff the bow from the top down by pulling your three loops with one in the center and one on each side. Repeat until the entire bow is fluffed. Adjust ribbon tails.
Video
Notes
** To create the look of a Christmas tree topper bow with long flowing tails, cut extra lengths of ribbon according to the height of your tree.