Add a dab of glue on the back of your face sign at the top, bottom, and both sides (4 dabs total). Then attach your mounts in those spots.
Cut 2 pipe cleaners in half. Slip each half through your glued-on mounts and twist to secure.
grab your wire wreath frame, with the pipe cleaners pulled away from the center. Attach your snowman face sign with the pipe cleaners on the back. Tie them to the center of the wire wreath frame. I recommend attaching opposite sides first to make sure that your sign is centered.
Take your thicker mesh (not the iridescent one) and cut it to 35 inches. Do it 7 more times for a total of 8.
Take your thinner mesh (the one that's iridescent) and cut it to 30 inches. Do it 9 more times for a total of 10.
Start with your bottom ruffle layer. Using the iridescent mesh, curl the ends under, then scrunch the ends towards the middle to create your ruffle.Use the pipe cleaners on the bottom layer of the wreath frame and tie one around the middle of each ruffle. Do this process 10 times total.
Next, move to the ruffles on the top layer. Create ruffles with each of the 8 pieces of mesh and attach to the top layer of the wreath frame with pipe cleaners.
Insert the stem of the hat between the top layer of mesh and the bottom layer of mesh. Then secure it on the back of the wreath frame with a zip tie.
Fluff out the mesh on your wreath, making sure that you can see the face but not the wreath frame.