Start with a 2.5" ribbon and make a 12" tail. Place the tail into the EZ Bow Maker and then make 2 7" loops. Then trim the ribbon from the spool. Repeat the same process with the next 2.5" ribbon but make 4 loops this time.
Next take another 2.5" ribbon and measure another 12" tail and make 2 loops that are slightly smaller than your last ones. Repeat the same process with the next 2.5" ribbon but make 4 loops this time.
Make a tail and 2 loops with the next 2.5" ribbon and then switch to the 1.5" ribbon and make a tail and 4 loops. With the next 1.5" ribbon make a tail and 2 loops. With the final 1.5" ribbon make 2 tails and 1 loop.
With your first 1.5" ribbon make a tail and 4 loops. Then make a tail and 2 loops with the last 1.5" ribbon.
Take two pipe cleaners and twist the ends together to make one long pipe cleaner. Remove your bow from the bow maker and use the long pipe cleaner to secure the center of the bow twisting it off at the back.