Measure 12-inch tails with the pretty side always up.
Measure a 12-inch tail for your solid purple ribbon with a 4.5 inch loop, pinch, twist, and repeat then cut the tail.
Measure a 12-inch tail for your polka dot ribbon with a 4.5 inch loop, pinch, and twist. Do that again and cut the tail.
Grab your diamond ribbon and make a 3-inch loop with a shorter tail for the top of the bow. Pinch it, twist it, and repeat the process. Cut the tail.
Measure a 6-inch tail on your solid green ribbon with a 3 inch loop, pinch, twist, and repeat. Cut the tail.
Grab your sheer ribbon and cut a 6-inch tail with a 3-inch loop, then pinch it, twist it and repeat before cutting the tail.
Take all of your ribbons and cut 12-inch tail strips. Layer them on top of the bow staying in the same order that you used the ribbons in the bow. Finish the bow with a nice center loop made with the sheer ribbon.
Carefully remove the bow from the EZ Bow Maker. Careful - it's thick! Use your long pipe cleaner and push down in the middle as tight as you can while twisting the bow (not the pipe cleaner) to tighten it up.