Use your EZ Bow Maker and begin the first layer of your bow. Use the deco mesh ribbon and make 8-inch loops with 14-inch tails.
Next, make 2 slightly smaller loops with your 4-inch ribbon and 14-inch tails.
Make a 7-inch loop with 14-inch tails with your 3-inch ribbon
For the next layer, take another 3-inch ribbon and make 2 slightly smaller loops and 14-inch tails.
Make 2 6-inch loops and 14-inch tails with your 3rd 3-inch ribbon.
Use your 2-inch ribbon to make 2 slightly smaller loops and 14-inch tails.
With your second 2-inch ribbon, make a 5-inch loop with same length tails.
Use the third 2-inch ribbon to make 2 slightly smaller loops and 14-inch tails.
Take your 1.5-inch ribbon and make a 4-inch loop with 2 tails.
Lastly, make a smaller center loop and 2 tails with the 2-inch ribbon.
Your ribbon will be very thick. Pull it off your bow maker and turn the bow to tightly twist the pipe cleaner to secure it. Then attach pipe cleaners to both ends of your bow pipe cleaner to extend the ends of your pipe cleaner so it will attach to the wreath.
Notes
Your second bow will be smaller. Follow these steps:
Take your 4-inch ribbon and make a 6-inch loop with 8-inch tails.
Use your first 3-inch ribbon and make a slightly smaller loop and 2 tails.
For the next layers, grab your next 3-inch ribbon and make a 5-inch loop and same length tails.
Use your last 3-inch ribbon to make a slightly smaller loop and 2 tails.
With the first 2-inch ribbon, make a 2.5-inch loop and 2 tails.
Repeat with your 2nd 2-inch ribbon.
Take your 3rd 2-inch ribbon and make a center loop and 2 tails.
Pull your bow off the EZ Bow Maker and secure it with a pipe cleaner.
Your third bow will be the smallest. Follow these steps:
Use your 4-inch ribbon to make a loop and 2 tails.
With the 3-inch ribbon, make a loop and 2 tails.
Do this same process with your second 3-inch ribbon.
Repeat again with a 3rd 3-inch ribbon.
Take a 1.5-inch ribbon and make a loop and tails.
Repeat with the 2nd 1.5-inch ribbon.
Take your 2-inch ribbon and make a center loop with 2 tails.
Remove the bow from the bow maker and secure it with a pipe cleaner.