Then take your orange deco mesh and start a poof by folding the end under and curling in the sides. Attach it to your fluffed out greenery base using the greenery branches to attach the end of your poof to the wreath base.
Make a 12” poof attached at about 8 inches apart. Continue this process all around the wreath (9 poofs around the outside of the wreath).
Repeat this process, this time on the inside to cover up the inner part of the wreath. Cut the mesh.
Take your cut mesh pieces one at a time. Scrunch them in the center and attach each one at the same spot where your poofs attach along the outside of your wreath base.
Prepare to attach your bunny sign by taking a piece of craft foam and cutting out 3 1-inch squares. Stack the 3 squares on top of each other and put the stack on the back of the bunny head part of the sign. Add your pipe cleaner to the top of the stack then use your staple gun to attach the entire stack to the sign. Add a dab of hot glue to seal it.Repeat this same process two more times: midway down the sign and again at the bottom.
After the glue dries, attach the sign by pushing the pipe cleaners directly through the mesh and the wreath frame then twist to secure in the back of the frame.
Attach your bow to your wreath using the pipe cleaners.
Dovetail the bow tails. Fluff out your bow.
Make another (smaller) bow using the instructions provided.
Attach extra pipe cleaners to extend the length of the pipe cleaners on your bow so they will reach and attach to your wreath. Attach your bow to the top of your wreath and fluff it out and dovetail the tails.
Cut your 5-inch deco mesh into 14-inch strips. Scrunch them up and attach them to the outside of the wreath back.
Take your 4th 3-inch ribbon and cut it into 14-inch strips. Repeat this with your 1.5-inch ribbons.
Stack 4 strips of ribbon on top of each other. Scrunch in the middle and attach to the outside of your wreath. Repeat this process around the outside of the wreath.
Make your small bow following the instructions provided.
Extend the pipe cleaner by attaching 2 pipe cleaners. Attach to the wreath base, fluff it out.