Take your 21" mesh and fold over the end then add it into one of the ties on the top rung of the wreath frame. Then make a 10" poof and secure it into the next tie. Continue around the top rung and then the bottom one.
Take the 10" mesh and cut it into 18 20" strips. Then curl the ends in a little bit and scrunch it up the center to make a ruffle. Add that ruffle to a tie and repeat until all the ties have ruffle.
Now cut the 4" mesh ribbon into 18 30" strips. Make an awareness ribbon with each one. To do this fold the ribbon in half and then in half again. At the second fold pinch and twist and then add the twist into one of the ties on the top rung of the wreath frame. Repeat all around the top and then the bottom.
Next, attach 4 pipe cleaners to the back of your sign. To do this cut 4 squares of craft foam then put hot glue on the back of the sign, place a pipe cleaner on top of that, then use the staple gun to attach the foam and pipe cleaner. While the glue is drying cut your ribbon tails.
Cut 18 14" strips of the 2.5" ribbon then dove tail the ends. Next cut 36 14" strips of the 1.5" ribbon and dove tail the ends. Take one of the 2.5" tails and two of thee 1.5" tails and place them on top of each other. Fold the tails in half and pinch the center together. Attach the center pinch to a twist tie on the wreath frame. Repeat with the remaining ribbon tails and twist ties.
Now add your wreath sign to the center of you wreath by poking the pipe cleaners through the mesh and attaching them to your wreath frame.
Next attach your bow to the bottom right of your sign in the same way that you did the sign. Dovetail the ends of your bow tails.
Use the wire cutters to trim your greenery and floral sprays. Use hot glue to attach them evenly through the wreath to the ties on the frame. Be sure to add some to your bow too.