Cut both pink meshes into 10" strips. To cut the mesh lay it on a tempered glass board and use the wood burning tool to make your cuts. You need 40 pieces total, 24 of the pink and 16 of the window pane.
Cut the green mesh into 12" strips using the wood burning tool again.
Load the board full of zip ties and close them just a bit. You'll see exactly how to do this in the video.
Take one of your pink square and fold it in half to make a triangle. Then scrunch up the center and fold in half again. At the fold leave about an inch and then pinch. This is where you will add it to the zip tie. Starting at the second rung, add this to a zip tie with the petals pointing to the outside of the circle. Tighten down the zip tie. Repeat this process around that whole rung. When you're done with this rung use wire cutters to trim your zip tie ends.
Now move one rung inward and use the window pane mesh to fill in the zip ties just like you did in the last step. Trim your zip tie ends. Next, move one rung inward and repeat with the window pane mesh again.
For the center rung use the pink mesh again to fill the zip ties.
Use a pipe cleaner to make a hanger at the point in the outside ring where there are two holes right next to each other.
Now use the green to fill in the outer rung of the flower board.
Take the flower center and put a line of hot glue. Put a pipe cleaner along that line of glue. Take a small piece of fabric and glue it over the top of the pipe cleaner. Next take two u-pins and trim the ends. Add a little glue and push them through at an angle to secure the pipe cleaner in place.
Finally, add the flower center to the wreath using the pipe cleaner.