Take your EZ Bow Maker and your 4” ribbon and make a 8” loop with 16” tails.
Using a 2.5” ribbon, make two slightly smaller loops with 12” tails.
With another 2.5” ribbon, make a 7" loop and 16” tails.
With a 1.5” ribbon, make a slightly smaller loop and 16” tails
Grab the second 1.5” ribbon and make a 6” center loop and 16” tails.
Carefully pull your bow off the EZ Bow Maker. Wrap the pipe cleaners around the middle of your bow and twist the bow for a tight twist to secure your bow. Then extend the ends of your pipe cleaners with 2 additional pipe cleaners.
Bow #2
For the second bow, start with using your 4” ribbon to make a 7” loop and 8” tails. Take your next ribbon and follow the same process, continuing through the pattern of ribbon in your first bow.
Spread out the loops and tails of each ribbon layer so they make an “X”.
Carefully pull the bow off your EZ Bow Maker and secure it with your pipe cleaner then extend the ends of your pipe cleaner with additional pipe cleaners. Dovetail the ends of your tails.