Take the 2.5" ribbon and measure at 20" tail. Then pinch and twist and make a 7" loop. Continue to pinch, twist, and loop until you have 3 loops on each side. Then measure another 20" tail and trim it from the spool. Place this layer of your bow in the EZ Bow Maker.
Next use a 1.5" ribbon to make two 6" loops on each side, just like you did with the last layer. Then place it in the bow maker.
Repeat with another 1.5" ribbon, making 2 5.5" loops on each side.
Use another 1.5" ribbon to make a little loop for the center and one loop on each side.
Take two pipe cleaners and twist the ends together to make one long pipe cleaner. Remove your bow from the bow maker and use the long pipe cleaner to secure the center of the bow twisting it off at the back.