Start by measuring out a piece of 24-inch wire. You'll need 2 of these for each bow you make.
Grab one of the wires that you just cut and fold it in half. Measure your first ribbon at 6 inches, give it a pinch, and tie it off with the wire.
Take that ribbon and wrap it around your center peg. Give it a little pinch on the bottom then tie it with the wire and wrap the wire around the bottom peg. Tie if off on the top. This is your center loop.
Take the second piece of cut wire and fold it in half. Work it through the bottom of the ribbon that is the newly created center ribbon and twist it off using the wire.
Take your ribbon and loop up and around the center ribbon and around the next pegs on the left and right of the center ribbon. Then, tie it off at the bottom.
At this point, you’ll do the same with your third ribbon as well. Follow the same steps of grabbing your third wire, folding in half, circling around the bottom center loop, and around the next two pegs on the left and right that are currently empty.
For the final step of using up the four cut wires, do this exact same process again with the fourth ribbon and fourth wire.
Repeat these same steps until you’ve come to the end of the pegs. On the final peg, I like to use two ribbons at a time (instead of just one) and loop around the bottom and tie it off just to get it a bit of extra pizzazz.
Once tied, pull off the pegs and you’ve created your very own wreath bow!