Start by cutting 8 20" strips and 16 10" strips of the mesh. Then take two 10" strips, curl them loosely and criss cross them into an X. Add the center of the X to one of the ties on the bottom rung of the wreath. Repeat until all the ties on the bottom rung of the frame are full.
Now take your 20" strips and, one at a time, curl the ends in and then scrunch up the center to make a ruffle. Add one ruffle to each tie on the top rung of the frame.
Next use the staple gun to attach one pipe cleaner to each corner of your sign. Then add a dab of hot glue to secure the staples in place.
Now use the pipe cleaners on your sign to poke through the mesh and attach it to the center of the wreath frame.
Then add your bow to the bottom right hand corner of your sign. Fluff your loops and dovetail the ends.
Now use the ribbon tail board to cut 17 14" ribbon tails of the 2.5" and a 1.5" ribbon. Then dovetail the ends.
Next, take one of each type of ribbon tail and place one on top of the other. Fold the tails in half and pinch the center together. Attach the center pinch to a twist tie on the wreath frame. Repeat with the remaining ribbon tails and twist ties.