Grab your EZ Bow Maker and your ribbons. Start with a 4” ribbon, measure a 10” tail, twist the ribbon and then add it to the bow maker. Then make an 8" loop, twist, add it to the bow maker. Make another loop on the other side then trim after leaving a 10” tail.
Next, use another 4" ribbon and cut just a strip of it. Measure about 8", pinch the ribbon and then add the pinch to the bow maker.
Now take a 2.5" ribbon and make the tails and loops just like you did in step one but make your loops slightly smaller this time.
Repeat the same process with another 2.5" ribbon, making your loops slightly smaller again.
Next, do the same thing with a 1.5" ribbon. And again with another 1.5" ribbon.
Then, use another 1.5" ribbon to make two tails with one small center loop.
Take two pipe cleaners and twist the ends together to make one long pipe cleaner. Remove your bow from the bow maker and use the long pipe cleaner to secure the center of the bow twisting it off at the back.
Finally, dovetail the ends of your ribbon tails trimming them at different lengths.