Start by cutting 20 10" strips of your 10" mesh and 8 20" strips.
Next, take 2 of your 10" strips and roll them into loose curls. Make and X with the curls and add the center of it to one of the ties on the bottom of wreath frame. Continue this process until all the ties on the bottom rung are full.
Now take a 20" strip, curl up the ends just a bit, then scrunch it up the center to make a ruffle. Add the center or your ruffle to one of the ties on the top rung of the frame. Repeat this process until the whole top rung is full.
Use the super glue to attach 4 mounting squares to the back of your sign. Then thread a pipe cleaner through the mounting squares and twist them to secure them in place.
When your glue is dry, use the pipe cleaners to poke through the mesh and attach the sign to the top of your wreath.
Next, add the bow in the same way to the bottom of the wreath.
Now use the ribbon tail board to measure 8 14" tails of each of your ribbons. Dovetail the ends.
Take one 1.5" ribbon and one 2.5" ribbon tail and place one on top of the other. Fold the tails in half and pinch the center together. Attach the center pinch to a twist tie on the wreath frame. Repeat with the remaining ribbon tails and twist ties, alternating your colors as you go.
Finally, trim the tails of your bow to different lengths.