Start by cutting 10" squares of your burlap meshes. If you have a wood burner and tempered glass cutting board use those to make your cuts. If not, you can use scissors.
Next, load your zip ties into the first four outside rows of the UITC flower board, skipping the outside row. Close the zip ties but don't pull them completely closed. Then load the outside row, one zip tie per hole, and don't close them.
Now use the super glue to attach a cable tie mount to the back of your sign. Set it aside to dry.
Next, take a piece of your burlap and scrunch it corner to corner to make a ruffle. Fold the ruffle in half and then add it to a tie on the outside rung of the flower board. You want about an inch and a half of the fold to go through the zip tie. Pull the tie snug and then use the wire cutters to trim the ends. Continue this around the entire outside ring of the board.
For the next ring in, use the chocolate mesh. For the rest of the rings you will make your petals like this: fold one corner to the opposite corner to make a triangle. Make a slight fold at the center. Then loosely scrunch up a few inches on each side to make a petal. Attach them to all the zip ties on the second ring in just like you did your other petals.
Move to the next ring in and add burlap petals to each zip tie. For this layer, spread the two parts of the petal apart to open them up a bit.
Next, use the chocolate mesh to add petals to each tie on the next ring in.
Now push a pipe cleaner through the opening on your mounting square. Then, use the pipe cleaner to attach the sign to the center of the flower.