Prepare your sign to add to the wreath. Add a dab of superglue to all 4 corners of the back of the sign then top each dab with a mounting square. Add a little hot glue around the edges to secure them.Once the glue is dry, add a pipe cleaner to each mounting square.
Cut the stems off your greenery and floral picks.
Inspecting your grapevine base to see if there are any leaves or stems that stick out too far. Cut off any you find.
Grab your EZ Bow Maker and (4”) ribbon to start making your bow. Start by making (2) 7” loops with 12” tails in an “X” shape.
Grab your 2.5” ribbon and make 12” tails with two slightly smaller loops.
Take your 1.5” ribbon and make 12” tails with (2) 6” loops.Grab a pipe cleaner and wrap it around the middle of your bow. Twist the pipe cleaner to secure the bow. Use the same pipe cleaner to attach the bow towards the bottom outside of the wreath form.
Attach your sign to the wreath base using the pipe cleaners you added to the back.
Loosen up your greenery and begin adding it by adding a bit of hot glue to each stem individually and pushing it into the grapevine from each side of the bow.
Lighten up your greenery and add some whimsy by repeating the same process as you add the florals to your wreath.
Insert a couple of small sprigs directly into your bow for a fun touch. Trim your ribbon tails in a dovetail shape.
Trim the stems of the bee picks. Insert one pick into the wreath on each side of your bow. Adjust the bees into the greenery to make them look like they're buzzing around the design.