Start by measuring and cutting 2 pieces of 24-inch wire for each bow you want to make.
Take your first ribbon and fold one of the wires that you just cut in half. Measure 6 inches of ribbon, pinch it in the middle, and tie it off with the wire.
Next, wrap that ribbon around your center peg. Give it a little pinch at the bottom and tie it with the wire. Then wrap the wire around the bottom peg and tie it off on the top. This will be your center loop.
Now take the second piece of cut wire and fold it in half. Work it through the bottom of the newly created center ribbon and twist it off using the wire.
Loop your ribbon up and around the center ribbon and around the next pegs on the left and right of the center ribbon. Tie it off at the bottom.
Repeat the same process with your third ribbon. Grab your third wire, fold it in half, circle it around the bottom center loop and around the next two empty pegs on the left and right.
Repeat the same process one more with the fourth ribbon and fourth wire. Do these steps over and over again until you’ve come to the end of the pegs.
I like to use two ribbons at a time on the final peg to give the bow a bit of extra pizzazz. Tie it off.
Once tied, pull off the pegs and you have a wreath bow!