Make sure your wood cutout is clean and free of debris. Set it down on your workspace.
Carefully remove the paper backing from your vinyl decal. Lay your decal down with the image on your workspace and the sticky side up.
Carefully center your wood cutout over your decal and place it on top of your decal. Press down firmly.Flip your sign over and use your fingers to smooth your decal image out across your circle plank.
Flip your sign over again so the image is down on your workspace. From the back, use your Xacto knife to trim the overhanging vinyl edge to the same size as the circle plank.
(optional) If you want to seal your sign, apply Mod Podge over the back and sides. You don’t need to seal the decal side of your plank.
Attach mounting squares as needed to the back of your plank. Insert one pipe cleaner into each mounting square you attach.