Inspect your grapevine wreath base and cut off anything that will scratch your customer’s door or compromise the design.
Prepare the sign so we can attach it to the side of the wreath base.Punch a small hole in the top of your metal sign and another one in the bottom of your sign with a metal puncher.Cut a couple of pieces of floral wire several inches long and thread one piece through each hole in your metal sign. Twist the wires to secure them and use them to attach your sign to the wreath base.
Take your greenery stems and use spread them out. Insert them one by one into the grapevine base above and below the sign.
Take the light pink florals and open them up.Then add one stem to the top of the wreath and another to the bottom of the wreath. Then pull some of the greenery through so that it looks like one cohesive design.
Next, let’s take one more floral stem and add it to the design. We want to use it to fill in gaps, so use bolt cutters to cut the large stem off of the main stem. You’ll have two even stems that you can add to your spring lamb wreath.Insert one of these stems into the top of the design to fill it out. Then insert the second stem into the bottom of the wreath to fill in any gaps.
Take a stem of the small hot pink flowers and use the bolt cutters to cut the smaller stems off of the main stem.Add a dab of hot glue to each stem before inserting it throughout the design.
Take a stem of the small hot pink flowers and use the bolt cutters to cut the smaller stems off of the main stem.Add a dab of hot glue to each stem before inserting it throughout the design.
Take a stem of the Lamb’s ear greenery and use the bolt cutters to cut the smaller stems off of the main stem.Then add a dab of hot glue to each stem as you insert it into the design.
Cut a couple of strips of 2.5” ribbon and dovetail one end. Take the other end, fold it over, and put it in the pick machine to add a pick. Add a dab of hot glue to the end of the pick and insert it into the florals at the top of your design. Then do it again at the bottom of the design.
Let’s make a simple bow by hand!Take your first 2.5” ribbon and make (2) 18” tails with (3) 8” loops. Let the tails hang down.Now grab your second 2.5” ribbon and make (2) 18” tails with (2) 7” loops. Wrap a zip tie around the center of the bow and twist it tightly to secure your bow.Then take a long zip tie and use it to attach the bow to your wreath. Trim, curl, or dovetail, ribbons. Then fluff everything out. Your wreath is done!