112" Wreath signsupplier unknown *possibly Janes Front Door Decor
12.5" ribbonpaw print, RG5777X6
12.5 ribbonricrac print, RG206610
12.5" ribbongingham & dog print, RGA5894X6
11.5" ribbonSwiss dot, May 2022 Wreath Supply Box
11.5" ribbonpaw print, RG5776X6
Instructions
First add 12 pipe cleaners to the wreath form brackets, alternating between the inner most brackets and the outermost brackets.
Using a mesh cutter to trim the mesh into 20" sections.
Lay your mesh strip flat on the table, gathering at the middle to create a ruffle. Add the ruffle to the outermost pipe cleaners.
Cut your 2.5" paw print ribbon and ricrac ribbon into 14" sections.
Dovetail the ends. These will be your ribbon tails.
Stack the paw print pattern on top of the ricrac ribbon and attach to the outermost pipe cleaners.
Next, make more mesh ruffles and add to the innermost pipe cleaners.
Add the ribbon tails on top of the innermost pipe cleaners.
Trim the excess pipe cleaner stems.
Fluff out your ribbon tails.
Using a metal hole punch, create holes at the middle on the left and right sides of the sign.
Use a strong floral wire to fish through the holes on each side so you can secure to the wreath frame.
Create a bow.
Start with your 2.5" gingham and dog print ribbon. Create (2) 6" loops on each side. Make sure to pinch and twist in between each loop. Leave about a 9" tail on each side.
Layer on the 2.5" Swiss dot ribbon, creating (1) 5.5" loops on each side with 9" tails.
Next, add a layer of the 1.5" paw print ribbon. Create 3 loops on each side, making them progressively smaller.
Secure all the layers with a pipe cleaner.
Arrange your loops and tails. Dovetail ends of tails.
Attach the bow to the wreath, using the excess pipe cleaner on the bow.