Take each of the 18 pieces of mesh, scrunch down the center, and add to every wreath tie. This is the ruffle method. Do start at the bottom of the wreath frame and work your way to the top to avoid getting tangled up.
Get your wreath sign, craft foam, pipe cleaners, and staple gun. Add craft foam to each corner of the sign. Staple a pipe cleaner to each craft foam piece on the back of the sign.
Attach sign to wreath frame with pipe cleaners.
Add bows that you made to your wreath. Tie nice and tight.
Take 2.5" ribbon, measure 24-inches, fold it in half, told in half again. Add to wreath ties around your wreath. Take a 1.5" ribbon, and measure 24-inches, fold it in half, told in half again. Add to wreath ties around your wreath.
Get out your ribbon tail board, 2.5" ribbon, and 1.5" ribbon.
Wrap 2.5" ribbon around the ribbon tail board and cut into (10) 14" strips.
Cut ends into dovetails.
Wrap your other 1.5" ribbon around the ribbon tail board and cut into (10) 14" strips.
Cut ends into dovetails.
Wrap 1.5" ribbon around the ribbon tail board and cut into (10) 14" strips.
Layer (2) 1.5" ribbon strips on top of (1) 2.5" ribbon strip, fold in half, scrunch in middle, and add to the open wreath ties.
Fan out the ribbon tails. and Make sure it all points out to make the wreath look bigger.