Lay out your mesh, measure out 12" and cut your strips. You'll need about 13 strips. The amount will vary depending on the number of ties to your wreath frame.
Let the mesh roll up nice and loose, measure 5", tie to wreath form, make a poof and continue around the bottom of the frame. Make sure your curls are big. Fluff out the center to make the poof This is the curl and poof method.
Continue the same process with 2 layers all the way around the top of the frame.
Add the Terri bow you made for the body of the frog. Tie nice and tight to wreath frame.
Take attachment, lengthen the wire and attach it to the top of the bow. Tie to wreath frame.
Add the other attachment through the left and right side of the bow. Then the bottom two attachments below the bow. Use hot glue gun to reinforce the attachments.
Now we can add our other bows. Get your ribbons and EZ Bow Maker.
Using the 1.5" ribbon create an 8" tail on the bottom right. Make a 7" loop on bottom left, loop on top right, and end with 8" tail on top left.
Using the 2.5" ribbon create an 7" tail on top right. Make a 6" loop on top left, loop on bottom right, and end with 7" tail on bottom left.
Using the 1.5" ribbon create an 8" tail on the bottom right. Make a 5.5" loop on bottom left, loop on top right, and end with 8" tail on top left.
With deco tubing make a figure 8 and add to the bow maker.
Using the 2.5" ribbon create an 7" tail on the bottom right. Make a 4.5" loop on bottom left, loop on top right, and end with 7" tail on top left.
Using the 1.5" ribbon create an 7" tail on the bottom right. Make a 4" single loop on each side and cut the tail.
Take your pipe cleaner around the center of the bow, tie nice and tight, and arrange bow.
Repeat process and make 2 more bows.
Attach 1st bow on the bottom of the wreath wrapping the pipe cleaner around the metal frame, and fluff out bow.
Attach 2nd bow on the top of the wreath wrapping the pipe cleaner around the metal frame, and fluff out bow.
Attach 3rd bow on the left side of the wreath wrapping the pipe cleaner around the metal frame, and fluff out bow.
Take scissors and trim all the tails in to dovetails.
Take your (2) 1.5" ribbon, (1) 2.5" ribbon, and ribbon tail board. Measure 14" ribbon tails. Cut ends in to dovetails. You'll need 10 of each ribbon to fill bottom ties on the wreath.
Take (1) 2.5" ribbon and (2) 1.5" ribbon and layer. Take the 3 ribbons together, fold in half, scrunch in middle, and start placing them in the wreath with ends sticking outwards using a pipe cleaner and attaching to wreath form. Repeat and fill open spots. Fluff out tails outward away from your wreath.
Take your deco tubing and measure about 30" and twist and fold in 3s. Add throughout the wreath on top of ribbon tails.