Go Back
Print
Recipe Image
Notes
–
+
servings
Smaller
Normal
Larger
Print
3.50
from
2
votes
3-2-1 Bow Using the EZ Bow Maker
Learn how to make a 3-2-1 bow with the EZ Bow Maker
Yield:
3
bows
Materials
1
roll
10" deco mesh
10", 20", 25" cut
EZ Bow Maker
1
2.5" wired ribbon
2
1.5 wired ribbon
scissors
pipe cleaner
Instructions
Take out your deco mesh, EZ Bow Maker, and ribbon.
Bow #1: With your 10" cut of deco mesh, curl ends and scrunch to the center. Add to EZ Bow Maker. This will be the base of your bow.
Take your 1.5" ribbon and measure a 16" tail with (3) 7" loops on each side.
Using the same ribbon, measure a 16" tail with (2) 6.5" loops on each side.
Using the same ribbon, measure a 16" tail with (1) 6" loop on each side.
Using the same ribbon, measure a 16" tail and add a center loop.
Take 2 pipe cleaners and twist together to make a longer tie. Wrap tie around the center of the bow and twist nice and tight.
Fluff out your bow. Cut tails at an angle and curl your tails.
Bow #2: With your 25" cut of deco mesh, curl ends and scrunch to the center. Add to EZ Bow Maker. This will be the base of your bow.
Repeat steps 3-8 using a 1.5" ribbon.
Bow #3: With your 20" cut of deco mesh, curl ends and scrunch to the center. Add to EZ Bow Maker. This will be the base of your bow.
Repeat steps 3-8 using a 2.5" ribbon.
Notes
If you forget to add tails while making your bow, just cut a strip of ribbon tail and add it before you finish with your center loop.