This sweet ladybug grapevine wreath is super quick and super simple that you can easily decorate your front door or beef up your summer line in no time!
Take skewer and make whole in wreath sign. Thread floral wire where skewer was inserted and tie off. Secure with hot glue over the wires. Do this to the left, right side, and top of the sign.
Attach sign to the grapevine base. Add hot glue under the sign to secure to grapevine base. Let dry.
Get your EZ Bow Maker and ribbon.
With your 2.5" ribbon, measure a 12" tail and a 6" loop on each side. Cut tail.
Take your 1.5" ribbon, measure a 12" tail and (2) 5.5" loops on each side. Cut tail.
With your last 1.5" ribbon, measure a 12" tail and a 5" loop on each side. Cut tail.
Take a 1.5" ribbon and measure a tail and make a center loop.
Wrap a pipe cleaner around the center of the bow and tie nice and tight.
With your skewer, poke a hole on the bottom of your sign. Thread the pipe cleaner partially through the sign and the grapevine. Tie off nice and tight.
Fluff out bow and trim ends into dovetails. Curl tails.
Secure bow by adding a little bit of glue behind the bow.