Use the ruffle method on each piece of mesh and add to the evergreen wreath base.
Add scarecrow attachment to the right side of the wreath. Start by taking a piece of pre-cut floral wire and weave it into the back of the scarecrow attachment. Use a little bit of hot glue to patch up the attachment. Add a wire to the head and the bottom of the attachment.
Thread the floral wires of the attachment through the wreath base and twist it off.
Take bolt cutter and trim fall picks and sprays. With hot glue, secure the pieces of picks and sprays throughout the wreath.
Add bow you made using the Pro Bow to your wreath. Cut excess floral wire.
With the 4" wired ribbon, cut strips to make ribbon tails and add around the edges of your wreath.
Make a simple bow by hand: Start with the 4" ribbon, make a single loop. Then with the 2.5" ribbon, make a single loop and layer on top of the previous ribbon with loops facing opposite directions. Then with each 1.5" ribbon, repeat making single loops alternating the directions the loops are facing. Use a zip tie and tie around the center. Trim tails in to dovetails.
Using floral wire, thread through zip tie of the bow and add bow to the wreath.
Repeat 2 previous steps 3-4 times to make 3-4 bows and add to the wreath.
Fluff out bows and arrange to your preference.
Notes
Note: With attachments that have rocks or beads in it, you might want to get it out since it weighs down the attachment and will weigh down the wreath.