Take your 21" mesh, fold over the end and attach to a tie on the top of your wreath frame. Measure an 8" poof and attach to the next tie on the wreath frame. Continue this process around the top of the wreath frame and then on the bottom.
Next, take your first 10" mesh and use a rotary cutter to cut 9 15" strips. Make them into ruffles by curling under each end and then scrunching up the center. Attach the center point to every other tie on the wreath frame.
Then, take your second 10" mesh and cut 18 12" strips. Make these into curls two at a time and crisscross them. Add the center point to every other tie on the wreath frame.
Next, cut 18 14" tails of each of your three ribbons, dove tail the ends.
Layer your three ribbons on top of each other and fold in half. Attach the center point to each tie on the wreath frame.
Now it's time to attach the sign. Use a staple gun to attach a pipe cleaner to each corner of your sign. If your sign is thin be sure to attach a square of adhesive fun foam first so your staples don't pop through the front of the sign.
Finally, use the pipe cleaners to work through the mesh and attach the sign to the wreath frame.