Start by feeding the zip ties into the flower board. Put them through and close the zip tie, pulling them just a little bit.
Now cut your ribbon into 72 12" strips and then trim the ends at a diagonal.
Take two of your ribbon tails and place one on top of each other. Fold them in half and then give them a little twist. Then refold and pinch then add them to one of the zip ties on the outer edge of the board. Pull the zip tie tight then use needle nose pliers to pull it even tighter. Now fluff out your tails and repeat until each zip tie on the outer ring has been used.
Use wire cutters to trim the zip tie ends from the outer ring.
Continue this same method on each ring of zip ties, working one ring at a time towards the center.
Now add another zip tie to the center row of holes and add another set of tails to each one.
Next cut 4 6" strips of ribbon and zip tie the ends together. Trim the ends of the zip ties and use hot glue to attach your loops to the center of the flower.
Now use hot glue to secure your ornament to the center of the flower.
Finally, use a pipe cleaner to make a hanger on the back of your flower.