Take the large pink mesh and make 5 large poufs going around the frame to cover up the evergreen.
Take your rolls of 10” mesh and cut them into 30” strips to fill in any gaps the deco mesh left. Take each mesh strip and make individual ruffles before adding them onto your evergreen base.
Prepare to attach your Easter Bunny sign by cutting out small squares of craft foam and stacking them 2-thick. Take one pipe cleaner for each stack of craft foam squares and staple the pipe cleaners to the sign through the squares. Add a dab of hot glue to secure.Double check the front of the sign to make sure your staples didn’t poke through. Do this 3 times total across the back of your sign.
Make your bows while the hot glue dries.
Attach your bunny in an egg sign to your wreath with the pipe cleaners you just added to the back of the sign.
Now attach the bigger bow to the wreath on the left side of the wreath.
Attach your smaller bow to the top section of your wreath using the pipe cleaners.
Clean up the tails by dovetailing the ends. Then fluff the tails and bows.
Use a ribbon tail board to make 11 tails with two different 1.5” ribbons and one 2.5” ribbon. Cut the tails then dovetail the ends. Stack one of each of the 3 ribbon types, pinch them in the middle, and attach them to your wreath all around the outside of your base. Fluff out the tails and trim up the ends.
Fluff out and arrange your ribbons and trim up any tails that you want.