Grab the EZ Bow Maker and a 2.5" ribbon. Measure an 8" tail, twist the ribbon, and add it into the bowmaker. Make a 6" loop, twist the ribbon, then add it to the bowmaker and repeat on the other side. Trim a shorter tail this time.
Next use the 5/8" ribbon and repeat the same process making your tails even lengths this time.
Now use a 1.5" ribbon and repeat the same process again.
Repeat the same method with the other 5/8" ribbon.
Use the other 1.5" ribbon to make the last layer of your bow making the loops slightly smaller than the last ones.
Finally, take two pipe cleaners and twist the ends together to make one long pipe cleaner. Remove your bow from the bow maker and use the long pipe cleaner to secure the center of the bow twisting it off at the back.