Take your straw wreath and insert a metal floral pin through your ribbon and into the straw wreath to hold the ribbon down so you can wrap it around the wreath form.
Then begin wrapping the ribbon all the way around the straw wreath. End by pushing another metal floral pin into the wreath form and secure with a little bit of hot glue.
Grab your fabric mesh and place a pin on the backside of the wreath to hold the mesh onto the wreath.
Wrap the outside of the wreath with the mesh fabric, pinning it in place after completing each section. Go back and forth, keeping the mesh bunched in a cord-like manner. Continue until you have covered the entire front of the wreath, then trim off the mesh.
Take a foam core board and use an X-Acto knife to make his hat.
Use metal floral pins to attach the hat.
Cut eyes, nose, and mouth out of the foam core board.Add some Gorilla glue to the back of each piece and place them onto the mesh to create his face. Hold the pieces for at least 10 seconds to allow the glue to set.
Take 2 of your ribbons and cut out bands for the hat. Then make a 5-ribbon Terri bow using the Pro Bow The Hand.
Decorate the hat however you like using floral pins to keep everything in place.
When making the bowtie, split the tail of the mesh ribbon. Attach it to the wreath with a floral pin.