Start with a wood base and spray some foam in the middle and let sit. You do not need a lot but enough to have a good center to work with.
Next, fluff out your greenery swag base and lay it on top of your foam base using a Upin stem. Add glue to the Upin stem and push down into foam.
Cut your green tinsel spray into little picks. Then place hot glue on the bottom of the stems and push into the base of the foam. Add all around the greenery spray. Add one piece right down in the center of the centerpiece. This allows you to add height.
Using Mardi Gras picks with colorful beads add to the base and don't be shy. Placing these around the sides. Finishing them off with one near the center.
With the Mardi Gras Pick Spray separate the pick into sections. Allow you to work with just the colorful leaves add them in to the bottom right. Now grab the bead section of the spay wrap them around your finger allowing them to curl up. Place in the right side as well.
Repeat this step doing the same thing to the left side of the centerpiece.
Make and add a bow. Make two loops and add to the center of the centerpiece. Next, take your ribbon tails and tuck them into the centerpiece, and secure using your evergreen pine branches and secure. Dovetail the ends.
Add jester hat pick. Place glue on the stem and place it right in the center of the Mardi Gras Centerpiece
Thread a pipecleaner through the ring on the ornament and weave it through your branches of the evergreen. This will secure it to the centerpiece. Add another one on the other side to balance it out.
Add in Gold Fluer Pick
Place a stem into a foam ornament and let cool. Then place in an empty section.
Add a gold glittery boxwood stem around the ribbon to color up any holes you see.