Get out your EZ Bow Maker and your ribbons. Start with a 2.5” ribbon, measure a 12” tail, twist the ribbon and then add it to the bow maker. Then make a 7” loop, twist, and add it to the bow maker. Make another loop on the other side then trim after am 8”tail.
Next, use a 1.5" ribbon to do the same things but make your loops a little smaller this time.
Use the other 2.5" ribbon to repeat the same process, again making your loops slightly smaller.
For the last layer, repeat the same process with the other 1.5" ribbon.
Take two pipe cleaners and twist the ends together to make one long pipe cleaner. Remove your bow from the bow maker and use the long pipe cleaner to secure the center of the bow twisting it off at the back.