So we're going to start using an EZ Bow Maker and a 2.5" wired ribbon. Make a 12-inch tail on the bottom right and do one loop at about 7-inches. Do another loop on the top right, and end with a tail on the bottom left.
With your 1.5" wired ribbon, start with an 12-inch tail, and make 2 loops slightly smaller than the previous one on each side. End with a tail on the bottom left.
With another 1.5" wired ribbon, start with an 12-inch tail on the bottom right, and make a loop on each side and end with a tail.
With your 1.5" ribbon, make a single center loop.
Get some pipe cleaners, twist these together nice and tight. Fluff out your bow.
Take your bow and attach it to the bottom of your grapevine heart. Trim your bow tails.