DIY Stuffed Ladybug Deco Mesh Wreath
This ladybug wreath is made with a combination of ribbons, ruffles, and bows in complimentary red and black colors. This is the perfect way to jazz up a front door—watch the video and learn how to make it!
10" deco mesh
(7) 30" long and (18) 12" long
1.5 wired ribbon
EZ Bow Maker
ribbon tail board
Fluff out wreath form
Take your 10" mesh and cut (7) 30" pieces.
Take your deco mesh and do 12" cuts. Make 18 pieces.
Take each of the 12" deco mesh pieces, curl it and add 2 curls to every wreath tie on the outside.
Take the 30" pieces, curl the ends and then scrunch the center. Add to inside wreath ties. Alternate deco mesh colors. Fill the inside wreath ties.
Make 3 Terri bows using the tutorial above.
Take out 3 of your ribbons and your ribbon tail board. Make (13) 14" ribbon tails with each ribbon. Cut ends into dovetails.
Layer (3) 1.5" ribbon strips, fold in half, scrunch in middle, and add to the wreath ties on the outside.
Fan out the ribbon tails. and Make sure it all points out to make the wreath look bigger.
Add your attachment. Wrap wires around frame.
Add the Terri bows you made on your EZ Bow Maker. One below the attachment, one above, and one to the side.
Trim your ribbon tails of your bows.
Take your remaining ribbon tails and fill in the gaps.
How to Make Wreaths by DecoExchange