Grab your Pro Bow and move the pegs to row B or C depending on how large you want your finished bow to be.
Cut 2 wires 24" each.
Take all three of your 1.5" ribbons and stack them together.
Fold one piece of wire in half. Take the ends of your ribbon and pinch them together. Wrap the center point of your wire around the pinch.
Wrap your ribbons around the the first peg left of center, then back to your center peg. Pinch it around the peg and tie it off with the wire. Wrap one side of the wire around the peg and the other around the nail. Tuck the end that is around the nail under your Pro Bow to keep it out of the way.
Take the second wire and fold it in half. Slide it under the ribbon so it is vertical and twist the center around your center peg a few times. Put one wire up and out of the way and the second wire down and out of the way.
Pinch your ribbons right behind the center peg and twist, then wrap them around the peg just right of center, then back to the center. Pinch and twist, then repeat the wrapping process around two more pegs on each side, alternating sides.
Now use the second wire you attached to twist the center of the bow in its place.
Trim your ribbons off their spools leaving a tail, and dove tail the ends.
Now take your 2.5" ribbon and dove tail the end. Measure from your center peg all the way to the outside peg and pinch. Add the pinch right on top of where you just twisted the bow in place.
Next, wrap the ribbon around the next available peg on the right side, bring back to the center and repeat on the next available peg on the left side. Bring the ribbon back to center then pinch, twist, and tie off with the wire. Trim the ribbon from the spool and dove tail the end.
Repeat this method on the last two pegs.
Remove the wires from top and bottom and twist them all together at the center of the bow.
Fluff on the fluff box.
Notes
For more help, watch the video tutorial where I show you step-by-step how to make this Damon bow!