Take your first 2.5" ribbon, measure an 8" tail then make a 5.5" loop, inserting it into the EZ Bow Maker. Measure a 12" tail and cut from the ribbon roll.
Repeat using the 4" ribbon, making your loop on the other side.
Repeat using the second 2.5" ribbon.
Take a small bunch of raffia and add it to the EZ Bow Maker.
Next, make a second layer of tails and loops just like you did the first one but make this layer a bit smaller.
Add another small bunch of raffia.
Make another layer of loops and tails, smaller again than the last.
Take a small bunch of raffia, make a small loop and knot it. Add this to the center of your bow.
Take two pipe cleaners and attach them end to end to make one long one. Remove your bow from the bow maker and use the pipe cleaner to tie it off.