Grab your first 2.5" ribbon and make (2) 10" tails with (3) 6.5-inch loops. This layer will be the bottom layer in the EZ Bow Maker.
Take the second 2.5" ribbon and make (2) 10-inch tails and (3) 6" loops for this layer.Add this layer to the EZ Bow Maker on top of the first layer, placing the two tails on the opposite side of the EZ Bow Maker.
Next, take the first 1.5" ribbon and make (2) 10" tails with (3) 5.5" loops. Arrange this layer so that it alternates which side the tails go toward.
Finally, take your second 1.5" ribbon and create (2) 10" tails with four loops. The first loop will be a 4" center loop, and the other 3 loops will be 5".Place this layer on top of the previous layer in your EZ Bow Maker, alternating the side where the tails go.
Wrap a pipe cleaner (or zip tie) around the middle of the bow as you pull the bow out of the EZ Bow Maker.Hold the pipe cleaner behind the bow and twist the bow to tighten!
Lastly, open up the bow by spreading out the layers. Pull all the tails toward the bottom, and separate the loops. Fluff everything out and dovetail all the ends.