Thread your hanging material through the top of the sign and secure it before building the bow, so the piece is ready to hang once everything is attached.

Glue a few floral stems and black filler picks into the top left corner of the sign, angling a couple of stems outward past the edge so the arrangement does not look boxed in.

Cut loops from the 2.5 inch purple ribbon, the fancy panty swirl ribbon, and the Halloween ric rac ribbon. Cut two to three loops of each so all three prints are represented evenly in the finished bow.

Build the bow with the wider purple ribbon as the base layer, then add the swirl ribbon and the ric rac ribbon on top. Gather the center tightly and secure with floral wire or a zip tie.

Glue the finished bow into the floral corner, positioning it so the loops fan out over the base of the stems rather than sitting flat against the sign.

Separate the ribbon loops and tails so all three patterns are visible from the front. Check that no loop covers a ghost’s face before the glue fully sets.