Starting with your 2.5″ burlap wired ribbon create a 10″ tail and give a nice accordion pinch, leaving your tail pointing upward.

Next create a 7″ loop right almost like you’re going to make an awareness ribbon.

Leave yourself a nice long tail about 12″ inches”.

Next, incorporate the 1.5″ buffalo check ribbon. We’re going to repeat the same process, but facing the opposite direction.

Your loops will get a little smaller as you add more ribbon.

The 1.5″ bumblebee wired ribbon is next.

Now, here’s where we break pattern a little bit. Add a strip of the 2.5″ burlap ribbon to create tails on each side.

The last ribbon, the 7/8″ black ribbon will be used to create a center loop.

Use a pipe cleaner to secure, give it a couple good twists and wrap around again.