Go Back
–+ servings
Pink and White Mesh Valentine Flower Wreath
Print
No ratings yet

Valentine's Day White And Pink Mesh Flower Wreath

This quick and easy design stands out from the sea of Valentine's decorations and looks stunning anywhere!
Yield: 1 wreath

Materials

Instructions

  • Start by cutting (8) 11” strips of each of the poly burlap meshes with your wood burning tool. 
  • It's time to prepare the UITC board by inserting zip ties into the pairs of holes all the way around the board, skipping the outermost row.
    Add four extra zip ties in the innermost ring.
    Close all of the zip ties but don’t tighten them.
  • Start making dark pink petals. Take a strip of dark pink mesh and fold it corner to corner to create a triangle.
    Note: Since the strips aren’t perfectly square, you’ll have a little extra on each side.
    Scrunch the middle of the triangle into the center, then fold it so that the ends come together side by side. Insert the fold into a zip tie on the outside ring of zip ties around the UITC flower board. Pull the zip tie tight.
    Cut off any excess zip tie material. Repeat all the way around the board.
  • Repeat the same process with the light pink mesh strips. Add these petals to the zip ties on the middle row of the UITC board. Pull the zip ties tight and cut off the excess.
    Repeat all the way around the board.
  • Repeat the same process with the white mesh strips. Add these petals to the zip ties in the innermost row of the UITC board.
    Note: I find it easier to add them to every other zip tie first and then fill in the gaps. The center will get bulky as you add in the final four petals. That's ok.
    Pull the zip ties tight and cut off the excess. Repeat all the way around the board.
  • Take the Dollar Tree circle disk, the glitter rope, and the hot glue gun. Then coil the glitter rope onto the disk, using the hot glue gun to adhere it to the disk.
    After covering the front of the disk, bring the glitter rope down the side too.
    When you reach the end. Cut the glitter rope, leaving a little extra length (about 2 inches), and secure it with hot glue.
  • Take three metal u-pins and use wire cutters to shorten them, if needed. Add a dab of hot glue to the ends, then insert the first u-pin into the disk to hold the glitter rope in place.
    Use the other two u-pins to attach pipe cleaners to the back of the disks.
  • Attach the disk to the center of your flower mesh wreath by pushing the pipe cleaners you just attached through the holes of the UITC board. Twist the pipe cleaners together. Cut off any pipe cleaner excess.
  • Take a 3rd pipe cleaner and insert it into the two holes at the top of the board to create a hanger. Twist to secure and cut off any extra.

Video